30 docs tagged with "EC-XL"

Activation (the so-called zero touch provisioning, ZTP) results in the

If Application-based-routing (ABR) is not displayed in the EC Dashboard, this service option must be ordered in advance for each location.

Under Locations > Connected VPNs, you can assign the globally defined VPNs to the locations where they are to be used.

- An Access Control List (ACL) is a set of rules applied to a VLAN to control incoming and outgoing traffic.

The BGP configuration can be found under Locations > Routing.

DHCP Server for EC-S

You can configure Enterprise Connect M/L/XL locations in the Enterprise Connect Dashboard immediately after ordering in Order Management.

The Maximum Transmission Unit (MTU) for EC-M, EC-L, and EC-XL networks defaults to 1500 bytes but can be customized per VLAN on the router. IP packets exceeding the configured MTU size may be fragmented or discarded based on the "Don't Fragment" (DF) flag bit. The Maximum Segment Size (MSS) remains fixed at 1098 bytes, independent of the MTU setting.

- NetStream is a technology that collects IP packet statistics on a per-flow basis

- These instructions apply to Enterprise Connect versions S, M, L and XL.

- With QoS Traffic Remarking, the DSCP information of the IP data packets can be remarked in the router in the upstream direction (LAN to WAN). The original DSCP information will be overwritten.

- The QoS VPN-Cluster feature is needed to configure more than 8 VPNs at the EC-M/L/XL location or if more than 32 VPNs are required in the agreement.

Port configuration

- SNMP stands for Simple Network Management Protocol and is used to monitor the EC-M/L/XL routers.

- Wake on LAN (WoL) is an Ethernet networking standard that allows a computer to be turned on from sleep mode remotely.

- The following chapters describe the configuration options of the Enterprise Connect S, M, L and XL service.

Depending on the type of ordered EC-XL location, redundancy must be setup one of two ways:

- LAN Switches

This chapter shows an overview of the LEDs and connections on the

This chapter shows an overview of the LEDs and connections on the

This chapter shows an overview of the LEDs and connections on the

- If Hub&Spoke VPN is not displayed in the EC Dashboard, this service option must be ordered in Order Management below the Company module in advance. How to get into the ordering process: Order Management

This page describes how the individual router models have to be connected to the Enterprise Connect network (WAN) in order to perform the activation subsequently.

Physical installation

To commission Mobile Backup, the Mobile Backup option must be ordered at

- How to get into this ordering process: Order Management

- The OSPF configuration is a sub-configuration of the VLAN configuration.

- VLAN settings can be made under Locations > VLAN.

- If E2E Encryption is not visible in the EC Dashboard, you must enable this service option through Order Management before proceeding. This can be done by navigating to the company module section within the Order Management. For detailed instructions, refer to Order Management.

- The VRRP configuration is a sub-configuration of the VLAN configuration.