Configure EC-M/L/XL location
You can configure Enterprise Connect M/L/XL locations in the Enterprise Connect Dashboard immediately after ordering in Order Management. This means you do not have to wait until the router is physically up and running.
Configure general location settings
General settings can be found under Locations > Enterprise Connect on the respective location. You can activate or deactivate the location there.
Activating a location puts it into operation. Activating the first location in an agreement triggers additional provisioning steps, so special sizing requirements must be clarified in advance in consultation with Swisscom Support.
Deactivating a location deletes all its configurations and is therefore only advisable if the location is no longer needed or needs to be fully reconfigured.
Under CPE > Label you can configure the technical label of the location. You can search for it in the location search field and in the device search field.
Display of location information, which is configured in Order Management:
- Location reference of the location
- Quality of Service activated or not
- Bandwidth at the location
Router Status
- The status is displayed reactively, i.e. it is loaded when the location tile is opened and is only updated again when the refresh button is pressed.
- LED: Press the symbol so that front LEDs on the router start flashing for 30 seconds. This allows you to clearly identify the router.
Differences in configuring EC-XL locations
There are several differences when configuring EC-XL locations. These are listed on the following pages: