Skip to main content

Radius configuration on WLAN Access Points

  • How to get into the ordering process: Order Management

  • Standard IEEE 802.1X provides you with a general method for authentication and authorisation in IEEE 802 networks.

  • The prerequisite for this configuration is the:

  • To activate 802.1X on an access point, you must first create a WLAN and assign it to a group.

  • WPA2-ENT is mandatory as encryption for 802.1X.

  • If the encryption of a WLAN is changed (e.g. from WPA2 to WPA2-ENT), the WLAN must be deleted and created again with the required encryption.

  • Please go to locations > Access points you need to configure the defined WLAN broadcast SSID, and the primary and (if applicable) secondary Radius server. Registrate Radius server in the Dashboard

  • Also here you can overwrite the password (shared key) for this WLAN broadcast SSID, following the same procedure as for a LAN switch.

  1. Select the corresponding location
  2. Switch to the Access Points tab
  3. Add the WLAN broadcast

Complete configuration:​

  • All configurations are not actively written to the network components until you have sent the shopping cart.
  • You can do this after each step or (recommended) only after several steps.